Installation guide

Altitude 4760 Series Access Point Ports and Connections

Altitude™ 4760 Series Access Point Installation Guide

Altitude 4760 Series Access Point Factory Reset

Hardware Button

An Altitude 4760 Series Access Point can be physically reset using the hardware reset

button. The button is located inside the reset port on the bottom of the unit.

NOTE

This option is not supported by all Altitude 4760 Series Access Point software releases. Refer

to the release notes for the appropriate software.

The reset button is only enabled for a ten second interval as the unit boots up. It can be

accessed by removing the cover screw using a rachet driver and a #2 Phillips head adapter.

Push the button to reset the Access Point. Confirm that the reset cycle was completed and

replace the cover screw.

To perform an external hardware reset and restore the Access Point default settings:

1 Using a #2 phillips screwdriver, remove the cover screw from the external reset port.

2 Gently press and hold the reset button.

3 If any of LEDs 2 through 6 are active, it indicates that the unit has booted successfully

and the operational software is running.