Specifications

Altitude 4700 Series Access Point Product Reference Guide
499
AP4700>admin(system.snmp.traps)>set
Sets SNMP trap parameters.
Syntax
For information on configuring SNMP traps using the applet (GUI), see “Configuring Specific SNMP
Traps” on page 105.
set mu-assoc enable/disable Enables/disables the MU associated trap.
mu-unassoc enable/disable Enables/disables the MU unassociated trap.
mu-deny-assoc enable/disable Enables/disables the MU association denied
trap.
mu-deny-auth enable/disable Enables/disables the MU authentication
denied trap.
snmp-auth enable/disable Enables/disables the authentication failure
trap.
snmp-acl enable/disable Enables/disables the SNMP ACL violation
trap.
port enable/disable Enables/disables the physical port status trap.
dos-attack enable/disable Enables/disables the denial of service trap.
interval <rate> Sets denial of service trap interval.
cold enable/disable Enables/disables the system cold start trap.
cfg enable/disable Enables/disables a configuration changes
trap.
rogue-ap enable/disable Enables/disables a trap when a rogue-ap is
detected.
ap-radar enable/disable Enables/disables the AP Radar Detection
trap.
wpa-counter enable/disable Enables/disables the WPA counter measure
trap.
hotspot-mu-status enable/disable Enables/disables the hotspot mu status trap.
vlan enable/disable Enables/disables VLAN traps.
lan-monitor enable/disable Enables/disables LAN monitor traps.
rate <rate> <scope> <value> Sets the particular <rate> to monitor to
<value> given the indicated <scope>. See
table below for information on the possible
values for <rate>, <scope>, and <value>.
min-pkt <pkt> Sets the minimum number of packets required
for rate traps to fire (1-65535).
dyndns-update enable/disable Enables/disables dyndns update trap.
wlan-kerb-auth-fail enable/disable Enables/disables the WLAN Kerberos
authentication trap.
wwan-event enable/disable Enables/disables the WWAN event trap.
all enable/disable Enables/disables each trap.