Specifications

CLI Reference
Altitude 4700 Series Access Point Product Reference Guide
462
AP4700>admin(system)>set
Sets access point system parameters.
Syntax
admin(system)>set name phils
admin(system)>set loc engineering
admin(system)>set email [e-mail]
admin(system)>set cc us
admin(system)>set sslv2 enable
admin(system)>set weak-ssl-cipher enable
admin(system)>set sshv1 enable
admin(system)>set dns-relay-mode enable
NOTE
This name will appear in the WIPS server when one of the radios is configured as a sensor and the WIPS
functionality connects to the WIPS server. The WIPS module only accepts names with up to 20 characters, keep
that if intending to use this AP as a sensor.
For information on configuring System Settings using the applet (GUI), see “Configuring System
Settings” on page 78.
set name <name> Sets the access point system name to <name> (1 to 59 characters). The
access point does not allow intermediate space characters between characters
within the system name. For example, “AP4700 sales” must be changed to
“AP4700sales” to be a valid system name.
loc <loc> Sets the access point system location to <loc> (1 to 59 characters).
email <email> Sets the access point admin email address to <email> (1 to 59 characters).
cc <code> Sets the access point country code using two letters <code>.
led <mode> Sets the access point’s LED state.
dns-relay-
mode
<mode> Enables/disables DNS relay to prevent access to the port used by DNS.
sslv2 <mode> Enables/disables SSLv2 support for encryption and message authentication.
weak-ssl-
cipher
<mode> Enables/disables the AP to support SSL ciphers less than 128 bits in length.
sshv1 <mode> Enables/disables SSHv1 support for remote connections.