Specifications

System Configuration
Altitude 4700 Series Access Point Product Reference Guide
106
3 Configure the SNMP Traps field to generate traps when SNMP capable MUs are denied
authentication privileges or are subject of an ACL violation. When a trap is enabled, a trap is sent
every 5 seconds until the condition no longer exists.
4 Configure the Network Traps field to generate traps when the access point’s link status changes or
when the AP’s firewall detects a DOS attack.
5 Configure the System Traps field to generate traps when the access point re-initializes during
transmission, saves its configuration file. When a trap is enabled, a trap is sent every 5 seconds until
the condition no longer exists.
SNMP
authentication
failures
Generates a trap when an SNMP-capable client is denied
access to the access point’s SNMP management functions
or data. This can result from an incorrect login, or missing/
incorrect user credentials.
SNMP ACL
violation
Generates a trap when an SNMP client cannot access
SNMP management functions or data due to an Access
Control List (ACL) violation. This can result from a missing/
incorrect IP address entered within the SNMP Access
Control screen.
Physical port status
change
Generates a trap whenever the status changes on the
access point. The physical port status changes when a link
is lost between the access point and a connected device.
DynDNS Update Generates a trap whenever domain name information is
updated as a result of the IP address associated with that
domain being modified.
Denial of service
(DOS) attempts
Generates a trap whenever a Denial of Service (DOS)
attack is detected by the access point firewall. A new trap
is sent at the specified interval until the attack has
stopped.
Send trap every Defines the interval in seconds the access point uses to
generate a trap until the Denial of Service attack is
stopped. Default is 10 seconds.
WLAN Kerb Auth
Failed
Generates a trap when the Access Point detects a WLAN
Kerberos authorization failure.
WWAN Event Generates a trap when the Access Point detects the
presence of a 3G WWAN card, the Access Point
establishes (or fails to establish) a 3G WWAN connection,
or the Access Point detects a 3G WWAN card
disconnection, removal or resumed connection.
System Cold Start Generates a trap when the access point re-initializes while
transmitting, possibly altering the SNMP agent's
configuration or protocol entity implementation.
Configuration
Changes
Generates a trap whenever changes to the access point’s
configuration file are saved.
Rogue AP
Detection
Generates a trap if a Rogue AP is detected by the access
point.
AP Radar
Detection
Generates a trap if an AP is detected using a form of radar
detection.
WPA Counter
Measure
Generates a trap if an attack is detected against the WPA
Key Exchange Mechanism.
MU Hotspot Status Generates a trap when a change to the status of MU
hotspot member is detected.