Installation guide

Altitude™ 4532 Series Access Point Installation Guide
5
CHAPTER
1
Introduction
The Altitude™ 4532 Access Point, a component of the Extreme Networks
®
Wireless
Mobility System, links wireless 802.11a/b/g/n devices to the Summit
®
WM3000 Series
Controller, enabling growth of your wireless network with a cost effective alternative to
standard Access Points. The Altitude 4532 Access Point provides two placement options:
wall and ceiling. Wall mount slots fit onto two provided screws. Arrows on the case guide
the placement of the screws. For placement above a suspended ceiling, a safety wire tie
point on the case provides for a safety wire loop. The light pipe fits through a hole in the
ceiling tile to provide a view of the unit’s status lights.
The Altitude 4532 Access Point receives all power and transfers data through the same
CAT-5 or better Ethernet cable. There is no additional power supply required. An 802.3af
Ethernet controller or Power Injector is required.