Installation guide

External Antenna Model Suspended Ceiling Tile (Plenum) Mount Instructions

Altitude™ 4532 Series Access Point Installation Guide

5 If required, install and attach a security cable to the unit’s lock port.

6 Place the large corner of each of the case’s mount slots over the screw heads.

7 Slide the case down along the mounting surface to hang the mount slots on the screw

heads.

8 Attach appropriate antennas to the connectors.

9 Attach the Ethernet cable to the unit and to a controller with an 802.3af compatible

power source.

10 Verify the unit has power by observing that the LEDs are lit or flashing.

External Antenna Model Suspended Ceiling Tile

(Plenum) Mount Instructions

Ceiling mount requires placing the Altitude 4532 Access Point above a suspended ceiling

and installing the provided light pipe for viewing the status lights of the unit.

NOTE

Notes or warnings about suspended ceiling mounts apply to all installations where the unit is

placed on suspended ceiling tile. The case has a safety wire tie point for a standard safety wire.

CAUTION

Extreme Networks does not recommend mounting the Altitude 4532 Access Point directly to

any suspended ceiling tile with a thickness less than 12.7mm (0.5in.) or a suspended ceiling tile with

an unsupported span greater than 660mm (26in.). Extreme Networks strongly recommends fitting the

Altitude 4532 Access Point with a safety wire suitable for the specific installation. The safety wire

should be a standard ceiling suspension cable or equivalent steel wire between 1.59mm (.062in.) and

2.5mm (.10in.) in diameter.

This placement requires installation of the provided light pipe for viewing the status lights

of the unit.