Installation guide

External Antenna Model Wall Mount Instructions

Altitude™ 4532 Series Access Point Installation Guide

Wall Mount Procedure

1 Orient the case on the wall by its width or length.

2 Using the arrows on one edge of the case as guides, move the edge to the midline of the

mounting area and mark points on the midline for the screws.

3 At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall

mounting screw and stop when there is 1mm between the screw head and the wall.

NOTE

The recommended hole size is 2.8mm (0.11in.) if the screws are going directly into the wall,

and 6mm (0.23in.) if the provided wall anchors are being used.

4 If required, loop a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in diameter,

around the tie post and secure the loop.