Installation guide
Table Of Contents
- Table of Contents
- Introduction
- Hardware Installation
- Defining a Basic Configuration
- Specifications
- Regulatory Information
- Regulatory Overview
- Wireless Device Country Approvals
- Health and Safety Recommendations
- RF Exposure Guidelines
- International
- EU
- US and Canada
- Power Supply
- Radio Frequency Interference Requirements – FCC
- Radio Frequency Interference Requirements – Canada
- CE Marking and European Economic Area (EEA)
- Statement of Compliance
- Waste Electrical and Electronic Equipment (WEEE)
- Japan (VCCI) - Voluntary Control Council for Interference Class B ITE
- Korea Warning Statement for Class B ITE
- Other Countries
- Customer Support
Warnings
Altitude™ 4521 Series Access Point Installation Guide
7
Warnings
●
Read all installation instructions and site survey reports, and verify correct equipment
installation before connecting the Access Point.
●
Verify any device connected to this unit is properly wired and grounded.
●
Verify there is adequate ventilation around the device, and ambient temperatures meet
equipment operation specifications.
Site Preparation
●
Consult your site survey and network analysis to determine specific equipment
placement, power drops etc.
●
Assign installation responsibility to the appropriate personnel.
●
Identify and document where all installed components are located.
●
Ensure adequate, dust-free ventilation to all installed equipment.
●
Prepare Ethernet port connections.
●
Verify cabling is within the maximum 100 meter allowable length.
Package Contents
The Access Point ships with the following:
●
One Altitude 4521 Series Access Point
●
Installation Guide (This Guide)
●
Rubber Wall Mount Spacers (4)
●
LED light pipe and badge
●
Wall mount screw and anchor kit