Specifications

Extreme Networks Evaluation Guide: Altitude 4511 Access Point

Reset to Factory Defaults

There are two ways to reset the unit to factory defaults.

To revert to factory default conﬁguration using the

hardware reset button on the bottom of the unit:

1. Remove power from the AP

2. Using a paper clip, press and hold the reset button

on the back of the unit. The reset button is located

on the serial label, below the words “part number”

3. Apply power by connecting a PoE source

4. The amber LED will blink slow three times

5. When ithe Amber LED blinks fast, release

the button

6. The AP will continue to boot in its default conﬁgu-

ration state

From the webUI, navigate to the Operations main menu.

Select Reset (factory default) from the menu at the

bottom of the page. Click Execute.