Specifications

18
Extreme Networks Evaluation Guide: Altitude 4511 Access Point
© 2011 Extreme Networks, Inc. All rights reserved.
Click Management
Select Settings, Select the default Management Policy, click the Edit button
Select the access modes you wish to enable; Telnet, SSH, HTTP, HTTPS
Under Access Restrictions, select “source-address” as the Filter Type
In the “Source Subnets” field, enter 10.10.10.0/24
Click OK, then Exit
Edit the Dependent-AP Profile
webUI navigation: Configuration -> Profiles
Select dependent-AP4511, click Edit
Select your adoption policy from the drop down list
Click OK
Click Interface -> Ethernet Ports
Select FE1
Enter 100 as the Native VLAN
Click OK, then Exit
Select UP1
Set the mode to Trunk
Enter 100, 200, 300 in the Allowed VLANs box
Click OK, then Exit
Click add
Enter 100 in the VLAN ID box
Enter “Fast Ethernet port 1” in the description
Click OK, then Exit
Click add
Enter 200 in the VLAN ID box
Enter “Open WLAN” in the description
Click OK, then Exit
Click add
Enter 300 in the VLAN ID box
Enter “Secure WLAN” in the description
Click OK, then Exit
Click Radio
Select radio1, click Edit
Click WLAN Mapping
Select both of your WLANS from the right side, click the arrow to map it to
your radio
Click OK, then Exit