Specifications

17
Extreme Networks Evaluation Guide: Altitude 4511 Access Point
© 2011 Extreme Networks, Inc. All rights reserved.
Create a Primary Controller AP Profile
webUI navigation: Configuration -> Profiles (or edit the default Controller AP Profile to match your settings)
Click add
Assign a name, select the ALTITUDE 4511 type
Check the box to Set as Controller AP
Leave adoption policy at <none>
Click OK
Click Interface -> Ethernet Ports
Select FE1
Enter 100 as the Native VLAN
Click OK, then Exit
Select UP1
Set the mode to Trunk
Enter 5, 100, 200, 300 in the Allowed VLANs box
Click OK, then Exit
Click Virtual Interfaces
Click add
Enter 5 in the VLAN ID box
Enter management VLAN in the description
Enter 10.10.10.2/24 in the IP address field
Click OK, then Exit
Click add
Enter 100 in the VLAN ID box
Enter Fast Ethernet port 1 in the description
Click OK, then Exit
Click add
Enter 200 in the VLAN ID box
Enter Open WLAN in the description
Click OK, then Exit
Click add
Enter 300 in the VLAN ID box
Enter Secure WLAN in the description
Click OK, then Exit
Click Radio
Select radio1, click Edit
Click WLAN Mapping
Select your WLANS from the right side, click the arrow to map it to your radio
Click OK, then Exit
Click Network
Select Static Routes, click Add Row
Enter 0.0.0.0/0 in the Network Address field, and your router as the Gateway
Click OK, then Exit