Installation guide

Chapter 2: Hardware Installation

Altitude™ 4511 Access Point Installation Guide

7 Once cabled and powered, the Altitude 4511 Access Point functions as either a Virtual

Controller Access Point, Standalone Access Point or dependent mode Access Point, and

receives its configuration once adopted by a Summit WM3400, WM3600 or WM3700

series controller or Altitude 4511 Access Point functioning in Virtual Controller mode.

For information on using a controller to manage the Altitude 4511 Access Point, see:

http://www.extremenetworks.com/go/documentation

Telco Box Installation

For Telco Box installations, the Altitude 4511 Access Point is installed directly over the

standard wall plate supplying Ethernet. All cabled electrical connections are mode within a

recessed well in the housing of the Altitude 4511 Access Point.

To install the Altitude 4511 Access Point over a Telco Box:

1 Remove the cover of the CAT5 wall plate.

NOTE

The example above assumes the Telco Box has a 1 RJ11 phonejack and

1 RJ-45 10/100 Ethernet connection.