Specifications

CONFIG_MANAGER (2)
Summit WM Series WLAN Switch and Altitude Access Point Software Version 4.1 Technical Reference Guide
113
Major
9 Config Manager has experienced
an error which has prevented it
from properly processing a
request. CM will continue
running, however this error may
be an indicator of a larger
system problem. Error
Details:%s
Configuration/Administration
request may not have been
properly processed.
If problem persists, contact
Technical Support to investigate.
10 Access point%s has reported a
radar interference violation
on%s. The affected radio(s)
have been placed in auto
channel select mode, and will
not respond to channel changes
until 30min after the radar
interference is last detected.
Information. AP has responded
to Radar signal information.
None
11 AP [%s] has not responded to a
configuration change. The AP
has been sent a reboot
notification.
Access Point failed to
acknowledge configuration set.
AP may not be not be able to
provide service. Verify AP Image
version to validate that controller
and AP are properly matched.
If problem persists, contact
Technical Support to investigate.
Minor
33 Config Manager has failed to
process a request. Config
Manager is still running, and
system functionality is not
impaired. Error Details:%s
Configuration/Administration
request may not have been
properly processed.
If problem persists, contact
Technical Support to investigate.
Info
65 Shutdown sequence initiated. System is shutting down in
response to administration
operation (explicit request,
software upgrade, license key,
etc.…)
None
66 Shutting down normally. System is shutting down in
response to administration
operation (explicit request,
software upgrade, license key,
etc.…)
None
70 New product key has been
applied. Wireless Controller will
be rebooted.
System is shutting down in
response to administration
operation (explicit request,
software upgrade, license key,
etc.…)
None
Config succeeded. Serial
number:%s
Successful confirmation of AP
configuration.
None
Config failed. Serial number:%s Access Point upgrade fails. AP
may be prevented to register
with controller due to
configuration mismatch.
If problem persists, contact
Technical Support to investigate.
Table 16: CONFIG_MANAGER (2) logs and events (Continued)
Log
ID
Log Message Comment Action