Installation guide

Supplying Power to the Summit WM3700 wireless LAN controller
Summit
®
WM3700 Wireless LAN Controller Installation Guide
23
2 On the configuration computer, configure a terminal emulation application (such as HyperTerminal)
as follows:
Supplying Power to the Summit WM3700 wireless
LAN controller
1 Plug an approved AC power cord into the power connector at the back of the Summit WM3700
wireless LAN controller.
2 Plug the cord into a standard AC outlet with a voltage range of 100 to 240 VAC.
.
WARNING!
An improper shutdown can render the Summit WM3700 wireless LAN controller inoperable such that it
could require service by Extreme Networks Support. Do not remove AC power without first following the shutdown
procedure. An abrupt loss of power can corrupt the information stored on the device.
Verifying the Installation
View the LEDs on the front panel of the Summit WM3700 wireless LAN controller to ensure the device
is functioning properly. The normal LED pattern follows this path:
● During the Power On Self Test (POST), the System 1 and System 2 LEDs both blink green.
Terminal Type
VT-100
Port
COM port
Terminal Settings
19200bps transfer rate
8 data bits
no parity
1 stop bit
no flow control
no hardware compression
sym_0
Rack mount
bracket
AC inlet