Installation guide
Altitude 3510 Access Point Installation Guide 17
CAUTION
Ensure you are placing the antennas on the correct connectors to ensure the successful
operation of the AP3510.
NOTE
The AP3510 must be mounted with the RJ45 cable connector oriented upwards to ensure
proper operation.
9 Cable the AP3510 using an approved line cord and power supply.
For standard power adapter and line cord installations:
a Connect a RJ-45 Ethernet cable between the network data supply (host) and the
AP3510 LAN port.
b Verify the power adapter is correctly rated according the country of operation.
c Connect the power supply line cord to the power adapter.
d Attach the power adapter cable into the power connector on the AP3510.
e Attach the power supply line cord to a power supply.
CAUTION
Do not actually connect to the power source until the cabling portion of the installation is
complete.
NOTE
For other options to power up the AP3510, refer to “Powering the Access Point” on page 13.
10 Verify the behavior of the AP3510 LEDs. For more information, see “LED Indicators”
on page 23.
11 The AP3510 is ready to configure. For information on basic AP3510 device
configuration, see “Basic AP3510 Configuration” on page 25.