Installation guide

Altitude 3510 Access Point Installation Guide 15
For more information on the antenna options available to the AP3510, refer to the
Altitude™ 35xx/45xx AP Antenna Selection Guide available from
http://www.extremenetworks.com/go/documentation.
CAUTION
Ensure you are placing the antennas on the correct connectors to ensure the successful operation
of the AP3510.
4 Cable the AP3510 using either an 802.3af standard power source or an approved line
cord and power supply.
For standard power adapter and line cord installations:
a Connect an RJ-45 Ethernet cable between the network data supply (host) and the
AP3510 LAN port.
b Verify the power adapter is correctly rated according the country of operation.
c Connect the power supply line cord to the power adapter.
d Attach the power adapter cable into the power connector on the AP3510.
e Attach the power supply line cord to a power supply
CAUTION
Do not actually connect to the power source until the cabling portion of the installation is
complete.
NOTE
For other options to power up the AP3510, refer to “Powering the Access Point” on page 13.
5 Verify the behavior of the AP3510 LEDs. For more information, see “LED Indicators”
on page 23.
6 Return the AP3510 to an upright position and place it in the location you wish it to
operate. Ensure the AP3510 is sitting evenly on all four rubber feet.
7 The AP3510 is ready to configure. For information on basic AP3510 device
configuration, see “Basic AP3510 Configuration” on page 25.