Specifications

Altitude 3500 Series Access Point Product Reference Guide
91
To configure SNMP user access control for the AP35xx:
1 Select System Configuration > SNMP Access from the AP35xx menu tree. Click on the SNMP Access
Control button from within the SNMP Access screen.
2 Configure the SNMP Access Control screen to add the IP addresses of those users receiving SNMP
access.
Access Control List Enter Start IP and End IP addresses (numerical addresses
only, no DNS names supported) to specify a range of user
that can access the AP35xx SNMP interface. An SNMP-
capable client can be set up whereby only the
administrator (for example) can use a read/write
community definition.
Use just the Starting IP Address column to specify a single
SNMP user. Use both the Starting IP Address and Ending
IP Address columns to specify a range of addresses for
SNMP users.
To add a single IP address to the ACL, enter the same IP
address in the Start IP and End IP fields.
Leave the ACL blank to allow access to the SNMP
interface from the IP addresses of all authorized users.
Add Click Add to create a new ACL entry.
Edit Click Edit to revise an existing ACL entry.
Delete Click Delete to remove a selected ACL entry for one or
more SNMP users.
OK Click Ok to return to the SNMP Access screen. Click Apply
within the SNMP Access screen to save any changes
made on the SNMP Access Control screen.
Cancel Click Cancel to undo any changes made on the SNMP
Access Control screen. This reverts all settings for this
screen to the last saved configuration.