Specifications

System Configuration
Altitude 3500 Series Access Point Product Reference Guide
88
To configure SNMP v1/v2c community definitions and SNMP v3 user definitions for the AP35xx:
1 Select System Configuration > SNMP Access from the AP35xx menu tree.
SNMP v1/v2c community definitions allow read-only or read/write access to AP35xx management
information. The SNMP community includes users whose IP addresses are specified on the SNMP
Access Control screen.
A read-only community string allows a remote device to retrieve information, while a read/write
community string allows a remote device to modify settings. Extreme Networks recommends
considering adding a community definition using a site-appropriate name and access level. Set up a
read/write definition (at a minimum) to facilitate full access by the AP35xx administrator.
2 Configure the SNMP v1/v2 Configuration field (if SNMP v1/v2 is used) to add or delete community
definitions, name the community, specify the OID and define community access.
Add Click Add to create a new SNMP v1/v2c community
definition.
Delete Select Delete to remove a SNMP v1/v2c community
definition.
Community Use the Community field to specify a site-appropriate
name for the community. The name is required to match
the name used within the remote network management
software.
OID Use the OID (Object Identifier) pull-down list to specify a
setting of All or a enter a Custom OID. Select All to assign
the user access to all OIDs in the MIB. The OID field uses
numbers expressed in dot notation.