Specifications

Altitude 3500 Series Access Point Product Reference Guide
67
CHAPTER
4
System Configuration
The access point contains a built-in browser interface for system configuration and remote management
using a standard Web browser such as Microsoft Internet Explorer, Netscape Navigator or Mozilla
Firefox (version 0.8 or higher is recommended). The browser interface also allows for system monitoring
of the access point.
Web management of the access point requires either Microsoft Internet Explorer 5.0 or later or Netscape
Navigator 6.0 or later or Firefox 3.0 or later.
NOTE
For optimum compatibility, use Sun Microsystems’ JRE 1.5 or higher (available from Sun’s Web site), and
be sure to disable Microsoft’s Java Virtual Machine if installed.
To connect to the access point, an IP address is required. If connected to the access point using the WAN
port, the default static IP address is 10.1.1.1. The default username is "admin" and password is
“admin123.” If connected to the access point using the LAN port, the default setting is DHCP client. The
user is required to know the IP address to connect to the access point using a Web browser.
System configuration topics include:
● Configuring System Settings on page 68
● Adaptive AP Setup on page 70
● Configuring Data Access on page 72
● Managing Certificate Authority (CA) Certificates on page 78
● Configuring SNMP Settings on page 86
● Configuring Network Time Protocol (NTP) on page 98
● Configuring LLDP Settings on page 100
● Logging Configuration on page 102
● Importing/Exporting Configurations on page 103
● Updating Device Firmware on page 107