Specifications

Altitude 3500 Series Access Point Product Reference Guide
585
Configure the following on the IKE Settings page:
Local ID type refers to the way that IKE selects a local certificate to use.
● IP—tries to match the local WAN IP to the IP addresses specified in a local certificate.
● FQDN—tries to match the user entered local ID data string to the domain name field of the
certificate.
● UFQDN—tries to match the user entered local ID data string to the email address field of the
certificate.
Remote ID type refers to the way you identify an incoming certificate as being associated with the
remote side.
● IP—tries to match the remote gateway IP to the IP addresses specified in the received certificate.
● FQDN—tries to match the user entered remote ID data string to the domain name field of the
received certificate.
● UFQDN—tries to match the user entered remote ID data string to the email address field of the
received certificate.
● Question 8: I am using a direct cable connection between my two VPN gateways for testing and
cannot get a tunnel established, yet it works when I set them up across another network or router.
Why?
The packet processing architecture of the access point VPN solution requires the WAN default
gateway to work properly. When connecting two gateways directly, you don't need a default
gateway when the two addresses are on the same subnet. As a workaround, point the access point's
WAN default gateway to be the other VPN gateway and vice-versa.
● Question 9: I have setup my tunnel and the status still says 'Not Connected'. What should I do
now?