Specifications

Altitude 3500 Series Access Point Product Reference Guide
582
13 Select Pre Shared Key (PSK) from the IKE Authentication Mode drop-down menu.
14 Enter a Passphrase. Passphrases must match on both VPN devices.
NOTE
Ensure the IKE authentication Passphrase is the same as the Pre-shared key on the Cisco PIX device.
15 Select AES 128-bit as the IKE Encryption Algorithm.
16 Select Group 2 as the Diffie -Hellman Group. Click OK. This will take you back to the VPN screen.
17 Click Apply to make the changes
18 Check the VPN Status screen. Notice the status displays “NOT_ACTIVE”. This screen automatically
refreshes to get the current status of the VPN tunnel. Once the tunnel is active, the IKE_STATE
changes from NOT_CONNECTED to SA_MATURE.
19 On access point #2/ Device #2, repeat the same procedure. However, replace access point #2
information with access point #1 information.
20 Once both tunnels are established, ping each side of the tunnel to ensure connectivity.
Configuring a Cisco VPN Device
This section includes general instructions for configuring a Cisco PIX Firewall 506 series device.