Specifications

Altitude 3500 Series Access Point Product Reference Guide
580
Configuring a VPN Tunnel Between Two Access Points
The access point can connect to a non-AP device supporting IPSec, such as a Cisco VPN device—labeled
as “Device #2”.
For this usage scenario, the following components are required:
● 2 access points (either an Altitude 3510 or Altitude 3550 model)
● 1 PC on each side of the access point’s LAN.
To configure a VPN tunnel between two access points:
1 Ensure the WAN ports are connected via the internet.
2 On access point #1, select WAN > VPN from the main menu tree.
3 Click Add to add the tunnel to the list.
4 Enter a tunnel name (tunnel names do not need to match).
5 Enter the WAN port IP address of AP #1 for the Local WAN IP.
6 Within the Remote Subnet and Remote Subnet Mask fields, enter the LAN IP subnet and mask of AP #2
/Device #2.
7 Enter the WAN port IP address of AP #2/ Device #2 for a Remote Gateway.
8 Click Apply to save the changes.