Specifications

Hardware Installation

Altitude 3500 Series Access Point Product Reference Guide

Altitude 3550 Wall Mounted Installations

Complete the following steps to mount the Altitude 3550 to a wall using the supplied wall-mounting

bracket:

1 Attach the bracket to a wall with flat side flush against the wall (see the illustration below). Position

the bracket in the intended location and mark the positions of the four mounting screw holes.

2 Drill four holes in the wall that match the screws and wall plugs.

3 Secure the bracket to the wall.

4 Attach the square mounting plate to the bridge with the supplied screws. Attach the bridge to the

plate on the pole.

5 Use the included nuts to tightly secure the wireless bridge to the bracket. Fit the edges of the V-

shaped clamp into the slots on the flat side of the rectangular plate.

6 Attach the radio antenna to their correct connectors.

7 Cable the Altitude 3550 using the Altitude 3550 Power Tap (Part No. 15729).

NOTE

Once ready for the final positioning of the access point, ensure the RJ45 cable connectors are oriented

upwards to ensure proper operation.

029