Specifications

Hardware Installation

Altitude 3500 Series Access Point Product Reference Guide

Refer to the following, depending on how you intend to mount the Altitude 3550:

● Altitude 3550 Pole Mounted Installations on page 50

● Altitude 3550 Wall Mounted Installations on page 52

Altitude 3550 Pole Mounted Installations

Complete the following steps to mount the Altitude 3550 to a (1.5 to 18 inch diameter) steel pole or tube

(using the mounting bracket):

1 Fit the edges of the V-shaped clamp parts into the slots on the flat side of the rectangular plate.

2 Place the V-shaped bracket clamp parts around the pole and tighten the nuts just enough to hold the

bracket to the pole. (The bracket may need to be rotated around the pole during the antenna

alignment process).

3 Attach the square mounting plate to the bridge with the supplied screws.

4 Attach the Altitude 3550 and mounting plate to the bracket already fixed to the pole.

5 Secure the Altitude 3550 to the pole bracket using the provided nuts.

NOTE

The Altitude 3550 tilt angle may need to be adjusted during the antenna alignment process. Verify the

antenna polarization angle when installing, ensure the antennas are oriented correctly in respect to the Altitude

3550's coverage area.

Fit the edges of the

V-shaped part into the slots

Tighten the

securing bolts

Attach the square

plate to the bridge