Specifications

Altitude 3500 Series Access Point Product Reference Guide
437
AP35xx>admin(system.snmp.traps)> set
Sets SNMP trap parameters.
set
mu-assoc : enable/disable MU Associated Trap
mu-unassoc : enable/disable MU Unassociated Trap
mu-deny-assoc : enable/disable MU Association Denied Trap
mu-deny-auth : enable/disable MU Authentication Denied Trap
:
snmp-acl : enable/disable SNMP ACL Violation Trap
snmp-auth : enable/disable Authentication Failure Trap
:
port : enable/disable Physical Port Status Change Trap
dos-attack : enable/disable Denial of Service Trap
interval : set Denial of Service trap interval
dyndns-update : enable/disable dyndns update trap
:
cold : enable/disable System Cold Start Trap
cfg : enable/disable Configuration Changes Trap
rogue-ap : enable/disable Rogue AP Detection Trap
ap-radar : enable/disable AP Radar Detection Trap
wpa-counter : enable/disable WPA counter measure
hotspot-mu-status : enable/disable hotspot mu status trap
vlan : enable/disable vlan trap
lan-monitor : enable/disable lan monitor trap
:
rate : set Threshold value for Rate and Scope Combination
min-pkt : set minimum packets required for RF Threshold
Traps to fire
all : enable/disable all traps
For information on configuring SNMP traps using the applet (GUI), see “Configuring Specific SNMP
Traps” on page 94.