Specifications

Altitude 3500 Series Access Point Product Reference Guide
411
AP35xx>admin(system.aap-setup)>show
Displays the access point’s Adaptive AP configuration.
Syntax
Example
admin(system.aap-setup)>show
Auto Discovery Mode : disable
Controller Interface : lan1
Controller Name :
Static IP Port : 24576
Static IP Addresses:
IP Address 1 : 0.0.0.0
IP Address 2 : 0.0.0.0
IP Address 3 : 0.0.0.0
IP Address 4 : 0.0.0.0
IP Address 5 : 0.0.0.0
IP Address 6 : 0.0.0.0
IP Address 7 : 0.0.0.0
IP Address 8 : 0.0.0.0
IP Address 9 : 0.0.0.0
IP Address 10 : 0.0.0.0
IP Address 11 : 0.0.0.0
IP Address 12 : 0.0.0.0
Tunnel to Controller : disable
AC keepalive : 5
Load Balancing : enable
Inactivity Timeout : 42
Current Controller : 10.255.108.37
AP Adoption State : AAP adopted, Both Portals Configured
admin(system.aap-setup)>
NOTE
The access point CLI is only the only AP interface that displays the adaptive AP’s adoption status and AP
run state. This information does not appear within the Adaptive AP Setup screen.
For information on configuring adaptive AP using the applet (GUI), see “Adaptive AP Setup” on
page 70.
For an overview of adaptive AP functionality and its implications, see “Adaptive AP” on page 547.
show Displays the access point’s Adaptive AP configuration.