Specifications

Altitude 3500 Series Access Point Product Reference Guide
299
AP35xx>admin(network.wan.nat)> set
Sets NAT inbound and outbound parameters.
Syntax
Example
admin(network.wan.nat)>set type 2 1-to-many
admin(network.wan.nat)>set ip 2 10.1.1.1 (this command is used when NAT is 1-to-1)
admin(network.wan.nat)>show 2
WAN IP Mode : enable
WAN IP Address : 157.235.91.2
NAT Type : 1-to-many
Inbound Mappings : Port Forwarding
unspecified port forwarding mode : enable
unspecified port fwd. ip address : 111.223.222.1
one to many nat mapping
-------------------------------------------------------------------------------
LAN No. WAN IP
-------------------------------------------------------------------------------
1 157.235.91.2
2 10.1.1.1
For an overview of the NAT options available using the applet (GUI), see
“Configuring Network Address Translation (NAT) Settings” on page 129.
set type <index> <type> Sets the type of NAT translation for WAN address
index <idx> (1-8) to <type> (none, 1-to-1, or 1-to-
many).
ip <index> <ip> Sets NAT IP mapping associated with WAN address
<idx> to the specified IP address <ip>.
inb <index> <ip>
<mode>
Sets inbound IP address for specified index <index>
<ip address>
Sets inbound mode for specified index <index>
<enable/disable>
outb <index> <ip>
<from> <to>
Sets outbound IP address for specified index <index>
<ip address>
Sets outbound NAT destination <LAN1 or LAN2>
<WAN ip 1-8 or None>.