Specifications

Configuring Access Point Security
Altitude 3500 Series Access Point Product Reference Guide
190
To configure Altitude 35xx subnet access:
1 Select Network Configuration > Firewall > Subnet Access from the Altitude 35xx menu tree.
2 Refer to the Overview field to view rectangles representing subnet associations. The three possible
colors indicate the current access level, as defined, for each subnet association.
3 Configure the Rules field as required to allow or deny access to selected (enabled) protocols.
Green Full Access No protocol exceptions (rules) are specified. All
traffic may pass between these two areas.
Yellow Limited Access One or more protocol rules are specified. Specific
protocols are either enabled or disabled between
these two areas. Click the table cell of interest and
look at the exceptions area in the lower half of the
screen to determine the protocols that are either
allowed or denied.
Red No Access All protocols are denied, without exception. No
traffic will pass between these two areas.
Allow or Deny all
protocols, except
Use the drop-down menu to select either Allow or Deny.
The selected setting applies to all protocols except those
with enabled checkboxes and any traffic that is added to
the table. For example, if the adoption rule is to Deny
access to all protocols except those listed, access is
allowed only to those selected protocols.