Specifications

Network Management
Altitude 3500 Series Access Point Product Reference Guide
114
To configure the Altitude 35xx LAN interface:
1 Select Network Configuration > LAN from the Altitude 35xx menu tree.
CAUTION
If deploying the access point as an AAP with a remote layer 3 configuration and the AAP is set for
Controller auto discovery (primary/standby), the access point will unadopt from its switch after a few moments.
To remedy this problem, ensure LAN1 has 802.1q trunking enabled and the correct management VLAN defined.
2 Configure the LAN Settings field to enable the Altitude 35xx LAN1 and/or LAN2 interface, assign a
timeout value, enable 802.1q trunking, configure WLAN mapping and enable 802.1x port
authentication.
Enable Select the LAN1 and/or LAN2 checkbox to allow the
forwarding of data traffic over the specified LAN
connection. The LAN1 connection is enabled by default,
but both LAN interfaces can be enabled simultaneously.
The LAN2 setting is disabled by default.
LAN Name Use the LAN Name field to modify the existing LAN name.
LAN1 and LAN2 are the default names assigned to the
LANs until modified by the user.