Installation guide

3-4 A
LPINE
3800 S
ERIES
S
WITCH
H
ARDWARE
I
NSTALLATION
G
UIDE
S
ERVICE AND
M
AINTENANCE
Figure 3-1: Alpine 3804 power supply
Caution: Ensure the latch covers the AC power connector. The power supply
cannot be removed or installed unless the connector is covered.
7 Make sure that the replacement power supply is right-side up as described by the
text on the front of the power supply, that the ejector/injector lever is open, and that
the safety latch covers the AC power connector.
8 Use the centrally mounted handle to slide the power supply into the bay. Use the
ejector/injector lever to engage/disengage the power supply connectors during the
last inch of insertion into the chassis.
Caution: Do not slam the power supply into the backplane. This will cause
damage and possibly require the return of the chassis.
9 Secure the power supply by tightening the screw on the ejector/injector lever using
a #2 Phillips-head screwdriver.
10 Slide the locking latch covering the AC power connector to the left until it locks into
the chassis.
38_pw
r
VHzA
100-120
200-240
50
60
13
6
VHzA
100-120
200-240
50
60
13
6
SLIDE TO REMOVE
45012
SERVICE
DC OK
DC OK
WHEN INSTALLED IN 3808 THIS WAY UP
WHEN INSTALLED IN 3804 THIS WAY UP