Installation guide

A
LPINE
3800 S
ERIES
S
WITCH
H
ARDWARE
I
NSTALLATION
G
UIDE
2-9
P
OWERING
O
N THE
S
YSTEM
3 To secure the module in the chassis, close the ejector/injector levers by pushing on
them toward the center of the module card, and tighten the screws using a
#2 Phillips-head screwdriver.
4 Repeat this procedure for the additional I/O modules, if applicable.
P
OWERING
O
N THE
S
YSTEM
To turn on power to the system, connect the AC power cable to the power supply and
then to the wall outlet. If you have installed two power supplies, connect both power
cables.
C
HECKING THE
I
NSTALLATION
After turning on power to the Alpine 3800 series switch, the SMMi performs a
power-on self test (POST). The LED labeled “DIAG” on the SMMi blinks green during
the POST. Once the SMMi is operational, each I/O module performs a POST.
For more information on the LEDs, refer to Chapter 1.
C
ONNECTING
E
QUIPMENT TO THE
C
ONSOLE
P
ORT
Connection to the console port is used for direct local management. The console port
settings are configured as follows:
• Baud rate — 9600
• Data bits — 8
• Stop bit — 1
• Parity — None
• Flow control — XON/XOFF
The terminal connected to the console port on the SMMi must be configured with the
same settings. This procedure is described in the documentation supplied with the
terminal.