Specifications

Clarifications and Known Behaviors
ExtremeWare 7.3.1b3 Release Notes 97
Configuration Options with Large Number of Interfaces
When selecting a configuration applet with a large number of configured interfaces, the traversal of the
VLAN interfaces by Vista can cause a Watchdog reset due to the task utilization of Vista during the
interface data collection. It is recommended that Vista not be used for configurations with Watchdog
enabled where the Vista Configuration applet is used with a large number of VLAN interfaces.
SNMP
Performing an SNMP Mibwalk and Polling qBridgeMIB Might Cause High Utilization
Performing an SNMP mibwalk and polling qBrigeMIB might cause high CPU utilization for the task
tSnmpd. You might see error messages similar to the following:
08/02/2004 08:36:32.66 <Warn:SYST> task tSnmpd cpu utilization is 81% PC: 80fed744
(PD3-3011496).
ESRP SNMP MIB Table Election Algorithms Missing
The following ESRP election algorithms are not included in the ESRP SNMP MIB table
extremeEsrpTable:
• ports-track-priority
• track-ports-priority
The extrmeEsrpNeighborTable should contain the following additional algorithms:
• ports-track-priority-mac
• priority-ports-track-mac
• priority-track-ports-mac
• track-ports-priority-mac
• priority-mac-only
• ports-track-priority
• track-ports-priority
(PD2-244686415)
The configure snmp community Command Replaced
The configure snmp community command has been replaced by the configure snmp add
community
command. Though you can enter the configure snmp community command, it has no
effect (PD2-225385999).
Only Warm Start Smart Trap Sent After Power Cycle
When a switch is power cycled, only a warm start smart trap is sent. Previously, a cold start smart trap
was sent (PD2-209311102).