Specifications

Clarifications and Known Behaviors
ExtremeWare 7.3.1b3 Release Notes 91
Unconfiguring a Slot will not Remove the Ports from Network Login and Network Login
Cannot be Disabled
When unconfiguring a slot with Network Login enabled on a port, Network Login is not removed.
However, the ports are removed from the default VLAN, and Network Login cannot be disabled on the
port because the VLAN does not contain the port. As a workaround, to disable Network Login on the
port, add the port back to the VLAN, and disable Network Login on the VLAN (PD3-3599531).
Proxy ARP Setting Should Take Effect When Network Login is Enabled
When the switch has a proxy ARP setting and Network Login is not enabled, the proxy ARP setting
works correctly. However, when you enable Network Login on the port, the actual MAC address is sent
back to the ARP request from the switch (PD3-3523432).
Wireless Clients Forced to Reauthenticate During Roaming
Wireless clients are forced to reauthenticate during roaming under the following conditions:
• When the default-user-vlan is set to wireless Mgmt VLAN
• When the use-dynamic-vlan is set to No in a dot1x configuration
(PD3-3514072)
Enhanced DOS Protect Rate-Limit Configurations Are Lost
Uploading or downloading configurations does not restore rate limiting for enhanced-dos-protect
rate-limit configurations (PD3-3305879).
Disable Trusted MAC Globally Will Not Automatically Remove Network Login Ports
Added as Tagged Port in other VLANs
You cannot disable trusted MAC when a Network Login port is added to a VLAN as a tagged port
without first removing the port from the tagged VLAN manually. Running the
disable trusted-mac
command without first manually removing the port from the tagged port generates the following error
message:
Cannot disable Trusted MAC first remove port 1:4 from Tagged VLAN voice
You must remove the Network Login port added as a tagged port in the other VLANs before you
disable trusted MAC (PD3-2257721).
After Network Login Authentication, Cannot Get an iP Address from the DHCP Server
After campus-mode web-based network login is authenticated, the authenticated client cannot get an IP
address from the external DHCP server. When network login is removed, you can get a DHCP address
from the external DHCP server. This only applies to the Alpine FM32T switch. As a workaround, after
you unconfigure the slot on the Alpine FM32T, you can get an IP address from DHCP after
authentication (PD2-241015302).
Wireless Ports Do Not Come Online if VLAN Gets IP Address from BOOTP
If configuring the default VLAN IP from BOOTP, the wireless ports will not come online.
Workaround. Manually configure the VLAN IP (PD3-3017425).