Specifications

ExtremeWare 7.3.1b3 Release Notes 9
Contents
Creating Access Lists from Multiple Sessions 83
5,120 Access Lists and SNMP 83
Monitoring QoS and the show port qos Command 83
MPLS 83
Cannot Delete TLS VLAN After Deleting TLS Tunnel When MPLS is Disabled 83
IP Interface of Local End-point VLAN for TLS Tunnel or VPLS Can be Modified 83
Clear Counters Command Does Not Clear RSVP LSP Count 84
Targeted LDP Sessions Become Operational When MPLS is Disabled 84
Targeted LDP Sessions do not Come Up When OSPF is Disabled and Router ID is Automatic 84
Bi-Directional Rate Shaping 84
Secondary MAC Used for Rate Shaping Not Released 84
Aggregate-Bandwidth Granularity Correction 84
SecureMac Flags Not Shown 85
Locking and Unlocking Learning 85
1000Base-T Ports as Loopback Ports 85
EAPS 85
Configuring Cross Module Trunking Causes EAPS Failure 85
Shared-Port Link ID Limits 86
EAPS Performance Statistics 86
ESRP and EAPS Secondary Port 86
Incorrect show vlan Output 86
IP Unicast Routing 87
Reset the FDB Aging Timer 87
No Static ARP Entries 87
ARP Entry Age 87
Multinetting and the Show VLAN Stats Command 87
Multinetting and VRRP 87
IPv4 Routing 87
PIM CRP Timer Error 87
RIP Routing 87
Problems with Default Route Origination Addition and Purging 87
RIPv1 Learned Routes Might Not Be Purged Immediately 87
RIPv2 Authentication 88
RIP in Conjunction with other Routing Protocols 88
OSPF 88
OSPF Originate Default Cost Can Be Set Incorrectly 88
LSA Batch Interval Not Supported 88
Static Route with Switch’s Address as Gateway Not Advertised 88
AS-external LSAs Might Not Be Regenerated 88
Error Message Not Generated 88
Disable OSPF Before Adding or Removing External Area Filters 88
IS-IS 88
Unicast Packets Considered Broadcast 88
BGP 89
A Session Down Due to Max Prefix Limit Will Not Re-establish 89
Large Number of Access Profiles and a Peer Reset 89
Default Route Might Not Be Deleted 89
BGP Aggregation with a Maximum Prefix of 300,000 89
Redistributing BGP Routes to OSPF 89