Specifications

Clarifications and Known Behaviors
ExtremeWare 7.3.1b3 Release Notes 73
Workarounds.
Connect through the Management port.
Change your terminal setting to Ctrl+M instead of CR+LF (TELNET new line) if using PuTTY
version 0.54.
Use Tera Term. When using Tera Term, CR is sent by default instead of CR+LF.
(PD2-247002201)
Command Does Not Function
The functionality associated with the command configure wireless ports x:x interface x
client-scan keep-ies [on|off]
is not implemented. The command exists on the switch, but is not
functional (PD3-3004440).
show fdb vpls Command Does Not Accurately Show the Total of FDB Entries
The show fdb vpls command does not show the correct total of FDB entries running on the switch
(PD3-2780831).
clear counters Command Does Not Clear Number Transmitted in a MPLS Health Check
The clear counters command does not clear the number of VPLSPINGS sent by the switch
(PD3-2570481).
show fdb port Command Does Not Reflect Correct FDB Data for that Port
The show fdb portlist command shows the same total as the show fdb command for the entire
switch. For example, if you issue the
show fdb po 1:1 command, the output should show two MAC
addresses whereas a total of 55 is shown (PD3-1857861).
Maximum Number of ESRP Groups Supported in the ESRP MIB is Incorrect
The maximum number of supported ESRP Group and ESRP Neighbor Group is from 0 to 31, not 1 to
65535, as stated in the ESRP MIB table (PD2-244686417).
Not All configure debug-trace Options Are Displayed
The following configure debug-trace command options are available but are not displayed:
ap-scan
client-diag
mac-radius
wpa
iapp
(PD3-2179879)