Specifications

70 ExtremeWare 7.3.1b3 Release Notes
Clarifications, Known Behaviors, and Resolved Issues
ExtremeWare 7.0 (and Later) Does Not Support xmodem
You cannot use xmodem to transfer ExtremeWare 7.0 (or later) to an MSM (PD2-137101701).
4,000 VLANs on a BlackDiamond
If you configure more than 4,000 VLANs, EDP might crash, causing ESRP to fail (PD2-153821210).
E1 Module and the restart port Command
After you use the restart port command, E1 modules occasionally fail to establish a physical link
(PD2-85857901).
PPP Links Through E1 modules
PPP links through the E1 module are not always re-established after a reboot. To re-establish the PPP
link, use the
restart ports command (PD2-109252301).
Slot Failure Messages During a Broadcast Storm
If you have more than 15 Gigabit Ethernet links between two chassis, all in the same VLAN and
generating a broadcast storm, the system health check records slot failures in the log. When the
broadcast storm stops, the log messages also stop (PD2-117946811).
No Image Information Reported to SNMP with One MSM
If you only install an MSM in slot B of a BlackDiamond 6804, BlackDiamond 6808, or BlackDiamond
6816, no primary or secondary image information is reported to your SNMP NMS (PD2-129612901).
BlackDiamond 6816 MSM C and D Diagnostics Messages not in Syslog
If you run diagnostics on an MSM in slot C or D of a BlackDiamond 6816, messages are not recorded in
the syslog. To view the diagnostics messages, use the
show diagnostics command (PD2-118049501).
Disabling CLI Paging from the Slave MSM64i
Enabling or disabling CLI paging from the slave MSM64i has no affect on the master MSM64i paging
configuration (PD2-104377501).
The unconfig switch all Command
If you use the unconfig switch all command and immediately use the config default vlan
delete port all
command, the switch reboots (PD2-105474401). To avoid this situation, after you
unconfigure the switch, wait for the switch to completely reboot before you delete the ports.
BlackDiamond 6816 MIB Value for Input Power Voltage
On the BlackDiamond 6816, the extremeInputPowerVoltage attribute in extremeSytemCommonInfo is
shown as “0” and the extremePowerSupplyInputVoltage in the extremePowerSupplyTable is shown as
“unknown.” These values cannot be obtained from the switch (1-841J1).