Specifications

60 ExtremeWare 7.3.1b3 Release Notes
Clarifications, Known Behaviors, and Resolved Issues
Cannot Ping localHost Loopback Interface
You cannot ping the localHost loopback interface (PD3-2791311).
Hot-swapping an MSM3 Causes Invalid MAC Address on Backplane EEPROM
When you hot-swap an MSM-3, the following log message is generated:
CRITICAL ERROR: Backplane EEPROM has invalid MAC Address. System halted
(PD3-1514691)
MSM-3 Displays Broken Connection Recovered Message when Hot-swapping and
Inserting an MSM64i
If you hot-swap and insert an MSM64i and have an MSM-3 installed, the MSM-3 generates the
following log messages:
<Crit:SYST> The broken connection between MSM-A mother board port 24 and I/O module
1 port 6 is recovered
(PD3-1221174)
Hot-Swapping an MSM Causes I/O Modules to Reset
Hot-swapping an MSM generates the following log messages:
<Info:SYST> cardScan: <msm insert> Attempting to fix card 2 in reset <FFFFFFFF>.
<Info:SYST> cardScan: <msm insert> Attempting to fix card 4 in reset <FFFFFFFF>.
In the above message, card 2 and card 4 are not present; all of the other cards are present (PD3-1206991).
Downloaded Configuration Might Cause Syntax Error With Enable Web Command
A configuration file uploaded to a server, then downloaded to the switch, might cause a syntax error
when the switch reboots. The downloaded configuration file caused a syntax error when it reached the
entry, "enable web http access-profile none port 80" (PD3-3192200).
Wireless Error Messages Display During Bootup
If two APs are connected to the switch and are online when the switch is rebooted, the following error
messages are displayed during the reboot:
Jul 31 07:12:50 SYST: Invalid security profile with index 2
Jul 31 07:12:50 SYST: Port and interface binding not found
Jul 31 07:12:50 SYST: Request for req_type=WI_SECURITY_PROFILE: No such wireless
interface 3:1:1 (index=300101)
Jul 31 07:12:50 SYST: Request for req_type=WI_SECURITY_PROFILE: No such wireless
interface 3:1:2 (index=300102)
These messages only occur when no slot information is configured and do not impact switch
performance (PD3-3017484).
show pim snooping Command Shows an Incomplete List of Packets Snooped
The show pim snooping <vlan> command shows an incomplete list of the PIM control packets
snooped for the specified VLAN if you are sending more than 10 data streams. This is primary seen
with (S,G) entries (PD3-2721014).