Specifications

ExtremeWare 7.3.1b3 Release Notes 59
4 Clarifications, Known Behaviors, and
Resolved Issues
This chapter describes items needing further clarification, behaviors that might not be intuitive, and
issues that have been resolved since the last release. Numbers in parentheses are for internal reference
and can be ignored.
This chapter contains the following sections:
• Clarifications and Known Behaviors on page 59
• Issues Resolved in ExtremeWare 7.3.1b3 on page 104
• Issues Resolved in ExtremeWare 7.3.0b49 on page 105
• Issues Resolved in ExtremeWare 7.3.0b44 on page 107
Clarifications and Known Behaviors
Following are the clarifications and known behaviors in ExtremeWare 7.3. For changes made in
previous releases, see the release notes specific to the release.
General
HTTPS Access
HTTPS is only available on the Alpine switches (PD3-2489351).
Unable to Download Image to a Switch with 500 Configured IP VLANs
Reduce the number of configured IP VLANs to 400 on a switch with no management port. This would
allow you to download a new software image (PD3-3575589).
NP API Generates Error Messages When Disabling a Slot Containing an OC3 or OC12
Module
The NP API generates log error messages whenever you disable a slot that contains an OC3 or OC12
module. The same error messages are generated when you hot plug an OC3 and OC12 module. The
NPAPI can not reboot error message is continuos, occurring about every 5 (+/-) seconds, and will fill
up the log. You will also receive an oobPollTask error message about every 5 minutes (PD2-249436801).