Specifications

6 ExtremeWare 7.3.1b3 Release Notes
Contents
Memory Corruption with RRO on PATH Message 66
No Longer Display Stale TLS NHLFE Entries 67
MPLS Module Might Not Be Recognized 67
LSP NHLFE Not Updated 67
Removing Second MPLS Module Causes Traffic to Stop 67
Disabling One MSM Might Cause Loss of Throughput 67
Cannot Delete an LSP Previously Referenced by a TLS Tunnel 67
EAPS Trap Not Sent if Connection is Through I/O Port 67
The card-down Option 67
10 Gigabit Ethernet and CMT 68
XENPAK with the BlackDiamond 6816 68
Cross-Module Trunking Not Supported on MSM64i’s 68
Cross-Module Trunking Module Support 68
Master Slot Must Be Active for CMT 69
MSM-3 Log Might Be Out of Chronological Order 69
Source Addresses Might Age Out of FDB 69
Do Not Use Static FDB Entries with CMT 69
Saving Health Check Configuration After Failure Causes Console Crash 69
Diagnostics on MSM-3 with Hitless Failover Causes Failover and Spurious Message 69
Do Not Configure a Port-Based Backplane Algorithm When CMT is Enabled 69
Cross-Module Trunking and ACLs 69
ExtremeWare 7.0 (and Later) Does Not Support xmodem 69
4,000 VLANs on a BlackDiamond 70
E1 Module and the restart port Command 70
PPP Links Through E1 modules 70
Slot Failure Messages During a Broadcast Storm 70
No Image Information Reported to SNMP with One MSM 70
BlackDiamond 6816 MSM C and D Diagnostics Messages not in Syslog 70
Disabling CLI Paging from the Slave MSM64i 70
The unconfig switch all Command 70
BlackDiamond 6816 MIB Value for Input Power Voltage 70
Alpine 71
Mirroring Failure on an Alpine 3808 with GM4x Module After a Save and Reboot 71
With IE5.0 Vista Page is not Accessible Through HTTPS 71
Autonegotiation on VDSL Ports Set Incorrect Speed 71
VDSL Ports do not Support Jumbo Frames 71
New Accounts with WAN Module Installed are pppuser 71
Limited Commands Mode 71
VDSL Modules in a Half-Duplex Link 71
Summit 71
Spurious Summit48si Power Supply Messages 71
Output of the show log Command 72
The unconfigure switch all Command Clears the Default VLAN from s0 72
Health Check Error Messages 72
Summit48i Redundant PHY 72
Summit48i Single Fiber Signal Loss 72
SNMP Results for Power Sources 72
Summit48si MIB value for Input Power Voltage 72