Specifications

48 ExtremeWare 7.3.1b3 Release Notes

Upgrading to ExtremeWare 7.3

5 Download the BootROM using the download bootrom slot command.

6 Reboot the module using the

reboot slot command.

NOTE

If you are upgrading multiple modules, skip step 6, upgrade every module, then reboot the switch.

7 Download the latest ExtremeWare to the primary image space.

8 Reboot the module using the

reboot slot command.

Upgrade T1, E1, or T3 Modules from ExtremeWare 6.1.8b79 or Later

If you are using a T1, E1, or T3 module with ExtremeWare 6.1.8b79 (or later) and BootROM 2.8 (or

later), upgrade the module to ExtremeWare 7.3:

1 TFTP download the latest ExtremeWare for the module using the

download image slot primary

command.

2 Configure the module to use the primary image with the

use image primary slot command.

3 Reboot the module using the

reboot slot command.

Upgrade ATM, MPLS, ARM, or PoS Modules from a Release Prior to ExtremeWare 7.3

If you are using an ATM, MPLS, ARM, or PoS module with a previous ExtremeWare release or a

BootROM prior to 1.18, upgrade the module to ExtremeWare 7.3:

1 Upgrade your switch to ExtremeWare 7.3 by following the upgrade instructions “Upgrading

Switches to ExtremeWare 7.3” on page 44. When your switch is successfully booted on ExtremeWare

7.3.0 continue with step #2.

2 TFTP download ExtremeWare 7.3 for the module using the download image slot primary command.

3 Configure the module to use the primary image with the use image primary slot command.

4 Reboot the module using the reboot slot command.

NOTE

If you are upgrading multiple modules, skip step 4 until you have upgraded every module, then reboot

the switch instead of rebooting each slot.

5 Verify that the correct ExtremeWare is loaded using the show version command.

6 Download the BootROM using the download bootrom slot command.

7 Reboot the module using the

reboot slot command.

NOTE

If you are upgrading multiple modules, skip step 7, upgrade every module, then reboot the switch.

8 Verify the slot is operational using the

show slot <#> command.