Specifications

ExtremeWare 7.3.1b3 Release Notes 5
Contents
Downloaded Configuration Might Cause Syntax Error With Enable Web Command 60
Wireless Error Messages Display During Bootup 60
show pim snooping Command Shows an Incomplete List of Packets Snooped 60
MSM-Failover Link-Down Not Working on the Remote Side 61
ExtremeWare 7.3 introduces the concept of QoS profiles on a VLAN 61
Repeatedly Hot-Swapping the MSM Might Cause Loss of Connectivity 61
Cannot Save or Download a Configuration If a “ghost” Process is Running in the Background 61
Creating an ACL with a Filter-Precedence of 11 or 12 Generates a Conflict Error with
cpu-dos-protect 61
Hot-Swapping Modules Might Cause Misleading Error Messages 61
G12Ti Module Link Detection Fails 61
Autonegotiation Between Fiber Optic Ports is not Possible 62
show log Command Memory Error 62
unconfigure switch all Command Should Not Restore the Downloaded Configuration 62
WLANSYST Output of the show log Command is Not Correct 62
System Related – All Systems 62
The NVRAM Dirty Bit Being Set from the PoE Code 62
PoE Firmware image Download is not Available in Base Image 62
Autonegotiation Setting Not Preserved on Added and Deleted Loopback Ports 62
Configure Slot for PoE Before Configuring or Downloading PoE Configuration 62
The show log Command Truncates Long Commands 63
The show log Display Truncates Configuration Parsing 63
Do Not Create Single-Character Names 63
Smart Redundancy Enabled in Saved Configuration 63
Microsoft Load Balancing 63
Telnet and the show ports Command 63
The show configuration Output 63
Upgrading to ExtremeWare 7.0 and Bi-Directional Rate Shaping 63
Upgrading to ExtremeWare 7.0 and Debug-Trace 63
Upgrading to ExtremeWare 7.0 and OSPF 64
Blank Space in show port info detail Command Output 64
Using an ExtremeWare 7.0 Configuration with an Earlier Image 64
Console Response with a Large Number of ARP Entries 64
The show log chronological Command 64
BOOTP-Dependent Routes in Downloaded Configuration not Created 64
The disable learning Command and Flooding 64
Port Tag Limitation 64
WinSCP2 Not Supported 65
BlackDiamond 65
Twister Access Error 65
Loopback Port Must be on Same Module on a BlackDiamond Switch 65
Two Trap Messages Sent for Hard Reset/Soft Reset on BlackDiamond 6816 65
Targeted LDP Sessions Become Operational When MPLS is Disabled 65
BGP Fast Fail-over Does Not Work for Change of IP Address 65
CMT Group Will Not Forward Traffic Without a Master Slot 66
Connection to G12SXi Might be Lost 66
MPLS and ESRP 66
EAPS and Hitless Failover 66
Cross-Module Trunking and Hitless Failover 66
Autonegotiation Off Command Accepted on 10 Gigabit Ethernet Modules 66