Specifications

Upgrading ExtremeWare
ExtremeWare 7.3.1b3 Release Notes 45
5 Verify that all of the above procedures were completed successfully with the show switch
command.
6 Upload the configuration to a TFTP server for safekeeping using the
upload configuration
command.
Upgrade the BootROM to Version 8.2
Before you upgrade ExtremeWare, upgrade to BootROM 8.2 (BootROM 8.2 is compatible with all
ExtremeWare versions back to ExtremeWare 6.1.9):
1 Download the BootROM using the
download bootrom [<host_name> | <ip_addr>]
<ngboot82.bin_name>
command.
2 Reboot the switch using the
reboot command.
Upgrade to ExtremeWare 6.1.9
If you are running ExtremeWare 6.1.8 (or earlier), upgrade to ExtremeWare 6.1.9:
1 TFTP download ExtremeWare 6.1.9 to the primary image space using the
download image primary
command.
CAUTION
If you do not upgrade to ExtremeWare 6.1.9 before downloading ExtremeWare 6.2.2, the
ExtremeWare 6.2.2 download will fail, and the following message will be printed from the system:
ERROR: File too large
2 Reboot the switch using the reboot command. The previous configuration of the switch is
preserved.
3 Verify that the correct BootROM and ExtremeWare version are loaded using the
show switch and
show version commands.
4 Check the log for configuration errors. Manually enter configurations that did not load.
5 If you configured Random Early Drop Probability in ExtremeWare 6.1.8 (or earlier), re-configure the
Random Early Drop Probability using the
configure red drop-probability command.
6 Save the configuration to the primary space.
Upgrade to ExtremeWare 6.2.2b56
If you are running ExtremeWare 6.1.9 to ExtremeWare 6.2.2b43, upgrade to ExtremeWare 6.2.2b56 (you
can substitute ExtremeWare 6.2.2 builds 68, 108, 124, 134, and 156 for build 56):
1 TFTP download ExtremeWare 6.2.2b56 to the primary image space using the
download image
primary
command.
2 Reboot the switch using the
reboot command. The previous configuration of the switch is
preserved.