Specifications

106 ExtremeWare 7.3.1b3 Release Notes
Clarifications, Known Behaviors, and Resolved Issues
A range check is no longer needed to avoid system failures during snmpsetv (PD3-3455551).
You can now configure SSL HTTPS is enabled (PD3-2956151).
The show security-profile unsecure command no longer displays ports that are not capable
of wireless transmission and no longer displays interface 2 twice in the command output (PD3-3429031,
PD3-3197291).
UAA
Off channel AP scan now runs when the ALL channel option is selected (PD3-3839591).
QoS
Ingress QoS configurations are no longer accepted for non-Triumph ports (PD2-241056358).
PoE
The switch no longer downloads firmware when a firmware download is not required (PD3-2666565).
SNMP
When you configure a WEP client login and an 802.1x client login, a Network Login trap is now sent to
the switch (PD3-2707447).
ESRP
After you enable ESRP on a VLAN with an IP address and no active ports, and disable ESRP on that
VLAN, the route now becomes active (PD2-222505901, PD2-247722501).
CLI
When you create a VLAN (for example, v1), add a jumbo port, and assign an IP address to the VLAN,
the switch now prompts you with "
WARNING: Set MTU for v1 to support jumbo frames or IP
fragmentation with jumbo frames
.” To do this, use the configure ip-mtu <number> command
(PD2-241047417).
The watchdog no longer expires when generating an SSL certificate with a 4096-bit key (PD3-2944771).
The switch now automatically disables Web HTTPS after downloading a new certificate or private key
and enabling Web HTTPS (PD2-233940698).