Installation guide

Installing a BlackDiamond 6800 Series AC Power Supply
Extreme Networks Consolidated "e" and "i" Series Hardware Installation Guide 243
Figure 137: Orientation of the AC power supply in a BlackDiamond 6808 or a BlackDiamond 6804
CAUTION
Do not handle the power supply using the DC output bus bars. Support the power supply from the
bottom, while holding the handle on the front of the power supply unit.
Figure 138: DC output bus bars and connectors on a BlackDiamond power supply
Installing a BlackDiamond 6800 Series AC Power Supply
To install a power supply:
1 Attach the ESD strap to your wrist and connect the metal end to the ground receptacle on the top
left corner of the switch front panel.
2 Verify that the rack and chassis are grounded to protective earth ground.
3 If a blank faceplate is covering the power supply bay, remove it and save it for future use.
BD_033
DC OUT
AC IN
50021
POWER
V-50/60Hz
200-240V, 15A
XM_busbar
Connectors Bus bars