Installation guide

146 Extreme Networks Consolidated "e" and "i" Series Hardware Installation Guide
Alpine 3800 Series Switch Models
Figure 78: Rear panel of the Alpine 3804 switch
The rear panel of the Alpine 3804 switch provides:
• Access to the power supply
• Chassis grounding points
• System label, which includes:
— Chassis serial number
— Ethernet MAC address of the switch
— Symbols of safety certification
Alpine 3802 Switch
The Alpine 3802 switch consists of the following components:
• One 3-slot chassis, 4 U high, with backplane
• Three I/O module slots, labeled slots 1 through 3
• One integrated management module
• One or two preinstalled power supplies, either AC or DC
• One built-in fan tray containing three fan units; this fan tray is not customer-serviceable.
• One connector for an electrostatic discharge (ESD) wrist strap
• Six light emitting diodes (LEDs)
CAUTION
The Alpine 3802 switch has an integrated Switch Management Module (SMMi). The integrated Switch
Management Module is not hot-swappable or user removable. Do not attempt to remove the integrated
Switch Management Module. Contact Extreme Networks Customer Support if you experience problems.
38_rear4-b
VHzA
100-120
200-240
50
60
13
6
VHzA
100-120
200-240
50
60
13
6
SLIDE TO REMOVE
45012
SERVICE
DC OK
DC OK
WHEN INSTALLED IN 3808 THIS WAY UP
WHEN INSTALLED IN 3804 THIS WAY UP
Blank for
second
power
supply
Power
supply
Grounding
points
Label