Installation guide

36 Altitude 300-2 Getting Started Guide
Regulatory Compliance
This equipment meets the following conformance standards:
Japan
The Altitude 300-2 Models 15702 and 15703 are dedicated wireless ports designed for use in Japan to
meet specific regulatory requirements. These wireless ports do not require a country code to be entered
before operation. These units will automatically configure themselves upon connection to the switch
after inserting the Ethernet PoE cable.
Table 11: Canada Conformance Standards
Safety
• CULUS listed Acc. to CSA22.2
#60950-00
• Plenum Rated Enclosure w/o plastic cover
EMC
• ICES-003 Class B
Radio
Transceiver
• RSS-210
• RSS-139-1
• RSS-102 FR Exposure
• ID# 4141A-A300-2
Other:
• IEEE 802.11a (5 GHz)
• IEEE 802.11b/g (2.4 GHz)
• IEEE 802.3af
Note: Radio operation is controlled by firmware that is used only in A300-2 models 15700 and
15701. These models are for sale only in the US, Canada, and other countries that allow FCC
operating parameters.
Environmental
See Appendix A in this guide for a list of operating conditions.
Table 12: Japan Compliance Standards
Safety
• CB Scheme, IEC 60950:1999 with Japan
Deviation
• Plenum Rated Enclosure (w/o plastic
cover)
EMC
• VCCI Class B
Note: This is a Class B product based on the standard of the Voluntary Control Council for
Interference (VCCI) for informational technology equipment. If this equipment is used near a
radio or television receiver in a domestic environment, it may cause radio interference. Install
and use this equipment according to this instruction manual.
Radio Transceiver
• ARIB STD-T71, 5 GHz
• ARIB STD-T66, 2.4 GHz
• ARIB STD-33, 2.4 GHz
• IEEE 802.11a (5 GHz)
• IEEE 802.11b/g (2.4 GHz)
• IEEE 802.3af
Note: Radio operating parameters are
controlled by firmware that is only
released in Models 15702 and 15703 for
sale only in Japan.
Table 13: Antenna Output Power Density for Operation in Japan
For Integrated antenna:
• 11a: antenna power = 2 mW/MHz
• 11b: antenna power = 10 mW/MHz
• 11g: antenna power = 10 mW/MHz
For external antenna:
• 11a: antenna power = 2 mW/MHz
• 11b: antenna power = 4 mW/MHz
• 11g: antenna power = 4 mW/MHz