Installation guide

Altitude 300-2 Getting Started Guide 33
NOTE
The end user is responsible to enter the proper country code for the country of intended use. Extreme
Networks is not liable for improper country code configuration. If the first wireless port is in the North
American, Japan, or Taiwan regulatory domains, all sequential wireless ports must be the same
regulatory domain; otherwise additional wireless port will not be allowed to come up.
NOTE
To assure compliance, use only Extreme Networks certified antennas. Extreme Networks has not tested
or certified the use of Altitude A300-2 with any third party antennas. However, third party antennas may
be allowed for use within some countries. To assure compliance, only use antennas approved by
Extreme Networks or refer to country within this section for additional information regarding the use of
third party antennas.
The switch will automatically configure the Altitude 300-2 to operate within the proper frequencies and
power outputs determined by the country code entered. Incorrectly entering the country of operation
may result in illegal operation and may cause harmful interference to other systems. The user is
obligated to ensure the device operates according to the channel limitations, indoor/outdoor
restrictions, and license requirements for each country as described in this guide. Go to
http://www.extremenetworks.com/go/rfcertification.htm for a current list of country codes.
North America
The Altitude 300-2 models 15700 and 15701 (Group I) are designed for use in the United States, Canada,
and other countries that accept the U.S. regulatory requirements and limitations. For additional details
on the application of the Altitude 300-2 Model 15700 and 15701 to additional countries, go to
http://www.extremenetworks.com/go/rfcertification.htm and view the “Altitude 300-2 Certified
Countries” list.
The Altitude 300-2 for the North American regulatory domain provides for fixed frequency bands,
channel allocations of 1-11 and power output settings. This wireless port does not require a country
code to be entered before operation. The unit automatically configures itself upon connection to the
switch after inserting the RJ-45 Power over Ethernet (PoE) cable. Consult the appropriate Extreme
Networks software installation guide for further information.
United States - FCC Declaration of Conformity Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential and business environment. This
equipment generates, uses, and radiates radio frequency energy, and if not installed and used in
accordance with instructions, may cause harmful interference. However, there is no guarantee that
interference will not occur. If this equipment does cause harmful interference, which can be determined