Installation guide

16 Altitude 300-2 Getting Started Guide
Hardware Installation
Figure 6: Installation on a Hanging Ceiling
Some hanging ceilings have tiles with bottom surfaces that hang below the bottom of the T-bar. For
these ceilings spacers are provided. Place the spacers between the T-bar fasteners and the universal
mounting bracket as shown in Figure 7. Use a small piece of tape to hold the spacer in place on the
universal mounting bracket, and install the spacer and the bracket together.
Figure 7: Installation of Optional Spacer
Optional Antenna Shrouds
The optional plastic cover kit includes antenna shrouds for the integrated dual band antennas. Install
the antenna shrouds prior to enclosing the Altitude 300-2 in the plastic cover.
To install the antenna shroud, follow these steps (Figure 8):
1 Slide the antenna shroud over the antenna housing with the gear teeth next to the Altitude 300-2
unit. The shroud should be firmly seated on the antenna tube.
2 Clip the shroud onto the tube.
With the shroud installed, the antenna is still free to be rotated to the desired angle.
Mount the bracket on the
T-Bar fasteners and secure
it with the T-Bar nuts.
Downward Face
Of The T-Bar
Swing the arms
together to attach the
T-Bar fastener to
the T-Bar.
ALT006
Downward Face
Of The T-Bar
Optional Spacer
ALT007