Installation guide

Mounting Options
Altitude 300-2 Getting Started Guide 15
CAUTION
Make sure the holes in the lock hasps are lined up to ensure that the wireless port is completely
seated. Also make sure that the wireless port is engaged on all three mounting studs.
To remove the wireless port from the universal mounting bracket, follow these steps:
1 Remove the lock or cable tie.
2 Push the box in the direction of the lock hasp while gently lifting it away from the bracket.
NOTE
The universal mounting bracket is part of the Altitude 300-2 kit. Spares may also be ordered (Part
Number 15921).
T-Bar Fasteners and Spacers
The T-bar fasteners included with the Altitude 300-2 are designed to connect to a range of hanging
ceiling T-bar sizes.
To install the Altitude 300-2 on a hanging ceiling, follow these steps (Figure 6):
1 Open the T-bar fastener and place it on the T-bar.
2 Squeeze the fastener together until it is firmly seated on the T-bar.
3 With the two T-bar fasteners in place and properly spaced to match the brackets T-bar fastener
holes, determine if spacers are needed. The T-bar fastener spacers are designed for hanging ceilings
where the bottom surface of the ceiling tiles is below the T-bar. If this is the case, install the spacer to
allow the universal mounting bracket to sit below the bottom surface of the ceiling tile.
4 Install the universal mounting bracket using the large wing nuts provided. The bracket has
mounting holes that allow it to be installed inline with the T-bar, as shown in Figure 6, or at right
angles to the T-bar. Tighten the wing nuts.
CAUTION
it is recommended that you use two T-bar fasteners to connect the Altitude 300-2 to a hanging ceiling.
Make sure that the fasteners are securely on the T-bar before installing the universal bracket and
wireless port.