Installation guide

14 Altitude 300-2 Getting Started Guide

Hardware Installation

Figure 4: Universal Mounting Bracket

The universal mounting bracket contains numerous holes to support a variety of mounting options. The

large central hole is used to route cables when connecting the wireless port to in-the-wall cables. The

smaller holes can be used for connection to junction boxes or box hanger bars. Two cable tie loops are

provided for attaching standard nylon cable ties. A threaded stud is provided for grounding the plate, if

required by electrical codes. The lock hasp lines up with the lock hasp on the Altitude 300-2 and secures

the wireless port to the bracket. A lock or a cable tie can be placed in the lock holes.

Figure 5 illustrates the mounting options for the universal mounting bracket.

Figure 5: Mounting The Wireless Port On The Universal Mounting Bracket

To mount the Altitude 300-2 on the universal mounting bracket, follow these steps:

1 Place the mounting holes on the Altitude 300-2 over the mounting studs on the bracket.

2 Firmly slide the wireless port along the mounting studs until the holes in the lock hasps line up. The

unit is designed to snap into place, so some force is required.

ALT004

Cable Hole

Various

Mounting

Holes

Wall ViewFront View

Padlock Hole

Mounting

Stud (x3)

Cable

Tie (x2)

10-24 Threaded

Grounding Stud

ALT005

1 - Locate the three mounting

holes on the back of the box.

2 - Insert the bracket mounting

studs into the mounting holes.

3 - Firmly slide the box

down on the studs.

4 - The box is properly

installed when the lock

hasp holes are lined up.

5 - Secure the box with a padlock

or cable tie.